Audi EPC Light: What It Means, Causes and What to Do
Tips

Audi EPC Light: What It Means, Causes and What to Do

The EPC light on an Audi is the warning lamp for Electronic Power Control, Audi's electronic throttle system. A quick flash when you switch on the ignition is a normal self-test. If it stays on once the engine is running, or comes on while you drive, the engine computer has found a fault in that system and stored a fault code. Audi's manuals link it to parts such as the throttle body and the accelerator pedal sensor, and Audi's own bulletins point at wiring as well, so the first job is to read the code, not to buy a part.

Below is what Audi's own workshop manuals and service bulletins say the light means, which faults switch it on, and how to avoid paying for a throttle body you did not need.

Key Takeaways

QuestionQuick Answer
What does EPC stand for?Electronic Power Control, which Audi's TT workshop manual says refers to the electronic throttle control system.
Is it normal for EPC to light up at start-up?Yes. The engine computer switches it on with the ignition, and it should go out soon after the engine starts.
What turns it on while driving?A fault in the electronic throttle system, such as the throttle body or the accelerator pedal sensor. A fault code is stored at the same time.
Can I keep driving?You can, but the car may go into limp-home mode, and J.D. Power warns that driving on risks significant engine damage. Get it scanned soon.
Should I replace the throttle body first?No. For several 2005-2009 models, an Audi bulletin blamed the wiring and allowed the throttle to be replaced only if faults came back after the wiring repair.

Cutaway of an Audi saloon with callouts on the throttle body, engine control unit, a wiring harness connector, the ignition coils and the accelerator pedal sensor
Cutaway of an Audi saloon with callouts on the throttle body, engine control unit, a wiring harness connector, the ignition coils and the accelerator pedal sensor

What the EPC Light Means

Audi's workshop manual for the A2 puts it plainly: "EPC" is the abbreviation for Electronic Power Control. The manual for the 2005 TT 1.8T adds that EPC "refers to the electronic throttle control system". In other words, the accelerator pedal and the throttle are electronic parts that the engine computer watches all the time.

Source: Audi A2 workshop manual - Significance of EPC warning lamp

Source: Audi TT 1.8T (AWP) workshop manual - EPC warning lamp

The manual for the 2008 S4 4.2 V8 says the engine control module "monitors all EPC components after the ignition is switched on". If it finds a fault while the engine is running, it switches the lamp on, and the A2 manual adds: "Simultaneously an entry is made in the engine control unit fault memory." That stored code is what tells you, or your mechanic, where to look.

Source: Audi S4 4.2 (BHF) workshop manual - EPC warning lamp

Start-Up Flash or Real Fault?

The TT manual explains that the engine control module switches the EPC lamp on with the ignition, and that it "will go out soon after the engine starts" provided no throttle-system fault has been detected. Use this to read what you are seeing:

What you seeWhat it meansWhat to do
EPC lights with the ignition, then goes out soon after startingNormal self-testNothing
EPC stays on after the engine has startedA fault is stored in the electronic throttle systemHave the fault memory read
EPC comes on while driving and the car feels down on powerA fault, and the car may be in limp-home modeDrive gently to a safe place and get it scanned

Which Faults Switch It On

Audi's workshop manual for the A2's 1.4 petrol engine marks, in its fault table, each fault code that also lights the EPC lamp. The marked faults include:

  • Throttle valve control part (J338), implausible signal
  • Throttle angle sender 2 (G188), signal too low or too high
  • Accelerator pedal position sender (G79), signal too low or too high

For each one, the table's footnote reads: "Engine control unit switches on the EPC warning lamp in dash panel insert if this fault occurs."

Source: Audi A2 workshop manual - Fault table (SAE P0 codes)

Other engines use their own part numbers and codes, which is why the code from your car matters more than any general list. J.D. Power adds that, depending on the fault, other warning lights such as the check engine light may come on too, the cruise control can switch itself off and the stability control may stop working.

Source: J.D. Power - What Does EPC Mean on a Car?

EPC With the ABS Light On (A4, A5 and Q5)

If EPC comes on together with the ABS light, think wiring before throttle. Audi Technical Service Bulletin 45 14 08 is titled "ABS warning light on with additional warning lights on (EPB / TPMS / EPC / MIL) - wire harness damage". It covers the A4/S4 (2009-2013), A5/S5 (2008-2013), A5/S5 Cabriolet (2010-2013) and Q5 (2009-2013).

Audi's explanation: "The insulation for the ABS wheel speed sensor is damaged in production. Over time, this can lead to corrosion on the wires and restricted functions with the ABS control module." Only the wires in the left bulkhead grommet are affected. Besides the warning lights, the bulletin lists a steering wheel that does not lock, steering that feels stiffer than usual, an engine that cannot be switched off and an ignition key that cannot be removed. It also notes: "This condition does not result in any drivability concerns." The repair it describes is to fix the damaged cable in the wiring loom with a harness repair kit.

Source: Audi Technical Service Bulletin 45 14 08 (February 2014), filed with NHTSA

This bulletin was written by Audi of America, and the years are US model years. South African cars of the same models are not necessarily covered, so treat it as a strong lead for your mechanic rather than a guarantee. If you own one of these, our Audi Q5 spares and A4 parts pages list what we carry for them.

Don't Replace the Throttle Body First

A second Audi bulletin, 01 14 96, deals with throttle fault codes stored on petrol A3 (2006-2009), A4 (2005-2008), A4 Cabriolet (2007-2008), A6 3.2 FSI (2005-2008), TT (2008) and Q7 3.6 (2007-2009) models. The codes include P1545 (throttle control malfunction) and P0221, which the bulletin links to angle transmitter 2 for the throttle actuator, G188. That is the same sender the A2 fault table marks for the EPC lamp. Audi notes: "In most cases, the entries are sporadic."

The cause Audi gives is "contact resistance in the ECM wiring" to the throttle valve, and the repair is new wiring and connectors. The bulletin is blunt about the expensive part: "The main throttle is allowed to be replaced only if faults reoccur after the repair."

Source: Audi Technical Service Bulletin 01 14 96 (September 2014), filed with NHTSA

The A2 fault table gives the same advice for any component flagged as faulty: "First check the wiring and connectors to these components as well as the system earth connections." A throttle body that has been condemned on a code alone may be perfectly good. If you are weighing up repairs on an older A4 or A3, our guides to Audi A4 common problems and A3 reliability by generation cover the other faults to check.

What to Do When the EPC Light Comes On

  1. Note when it lit up. On with the ignition and off soon after starting is the normal self-test.
  2. If the car has lost power, take it easy. J.D. Power says the EPC may activate a "limp-home" mode to protect the engine, and warns: "While you can continue to drive with the EPC warning light on, you run the risk of doing significant damage to the engine."
  3. Read the fault memory. In J.D. Power's words, "An OBDII scanner is the best way to discover the source of the EPC light problem."
  4. Check wiring and connectors before parts, as Audi's own manual and bulletins advise.
  5. Replace a part only when the code and the checks point to it, and match the part number on the old unit.

Used Parts for EPC Faults

Once the fault is pinned down, a used part from a matching car can save you buying new. Our parts list includes throttle bodies, engine control units and wiring harnesses taken from Audis we strip for spares. Send us the part number from your old unit, or your VIN, through our contact page and we will check what we have. If driving on with the light has gone beyond a sensor, we also stock used Audi engines.

Audi Parts SA Editorial Team

Automotive Parts Specialists

Based in Lenasia South, Johannesburg, we supply used parts for all Audi models with nationwide delivery.

Disclaimer: This content is for informational purposes only and does not constitute professional mechanical advice. Always consult a qualified Audi technician for diagnosis and repair. Audi Parts SA assumes no responsibility for actions taken based on this information. Parts availability and prices are subject to change. View our privacy policy.

Frequently Asked Questions

What causes an EPC light to come on an Audi?
A fault in the electronic throttle system that the engine computer detects with the engine running. Audi's fault table for the A2 1.4 flags faults in the throttle valve control part, the throttle angle sender and the accelerator pedal position sender. Audi bulletins also point at wiring: damaged ABS sensor wiring on some 2008-2013 A4, A5 and Q5 models, and poor contacts in the throttle wiring on some 2005-2009 models.
Can I drive my Audi with the EPC light on?
You can, but the car may go into limp-home mode with reduced power, and J.D. Power warns that driving on with the EPC light on risks significant engine damage. Drive gently and have the fault memory read as soon as you can.
How do I fix the EPC on my Audi?
Read the fault code first, then check the wiring and connectors to the flagged part, as Audi's workshop manual advises. Replace a part such as the throttle body only when the code and those checks point to it. One Audi bulletin allowed the throttle to be replaced only if faults came back after a wiring repair.
How much does it cost to fix an EPC Audi?
It depends on the cause, which is why the fault code comes first. A wiring or connector repair is a very different job from a new throttle body or engine control unit. Once you know the part, send us the part number or your VIN and we will tell you what we have in used stock.
How serious is the EPC light?
A brief EPC light at start-up is a normal self-test. If it stays on or comes on while driving, a fault has been stored. J.D. Power notes it can be minor or serious, and that the cruise control and stability control may stop working, so have it checked soon rather than waiting.

Need Audi Parts?

Free quotes, quality used parts, nationwide delivery.

CallWhatsApp